Re: sanning veneer

Smaug Ichorfang <sm@[EMAIL PROTECTED]
> writes:

> "John Grossbohlin" <grossboj.nospam@[EMAIL PROTECTED]
> wrote in
> news:RsydnQzes8D7EfTVnZ2dnUVZ_r_inZ2d@[EMAIL PROTECTED]
 
>
>> Depending on how thick the stock is a simple stop or double sided tape
>> can be used to hold the work.
>
> How do you hold a 1/16 thick piece of wood to plane it?

As John said, "Depending on how thick the stock is a simple stop or
double sided tape can be used to hold the work."

I haven't tried this, but if you had some rubber non-slip material you
can use underneath it - similar to the cloths you can put on a
dashboard so your cellphone won't slip.

My MIY had some rubber disks used as jar openers, and she placed it
underneath a cutting board so it doesn't slip.

Another idea - I made a simple jig to hold the Shapton GlassStones. It
might be adaptable to planing thin stock. It had two stops, but was
wider than the material. I then took another piece of wood and cut it
at a diagonal, making two triangle-shaped wedges. I then tapped the
triangles together on the sides to wedge the item to the stops.