Mine does it too, but after I had to make adjustments to the mix. When I
first got it, I had to apply full trim to try to keep it from rotating and
it still did not stop it from turning that direction, so stick had to be
applied too. (So I thinks it's BS that they say that it was flown and
checked out at the factory as claimed) Anyway, I adjusted the mix and it
now hovers a good 10 seconds without input & trim centered. But ever
since
I did that, the pirouettes in the one direction I adjusted to are a wild
blur, while the other is a lot slower. My next issue to battle is forward
flight. I'll give it full stick forward and it takes off, but then slows
to
almost a hover while I have the stick still maxed out. The only way I can
keep forward momentum is by constantly increasing & decreasing a tiny bit
of
power (about one click back and forth) Swash Plate is adjusted
right....Anyone got ideas to correct this? (Sorry to hijack the thread a
bit, but it's still on topic!) :)
IYM
"Kevin" <dontemailme@[EMAIL PROTECTED]
> wrote in message
news:BuqNj.49362$h65.4705@[EMAIL PROTECTED]
> OK I know its a toy but do all balde CX-2's rotate quicker 1 one
direction
> than the other if you apply full tail/rudder ???
> --
> Kevin R
> Reply address works
|
