Thank you for the info. I have the Falcon 40 and I e-mailed tech sup****t
for this type of information. So far, I have not received a reply.
It would be nice when firms put out products, complete do***entation would
be included. All I had was the Transmitter and a plug that has a DB 9 pin
plug connected on one end and a 4 pin plug on the other end that goes to
the
Transmitter.
I have been using the e_sky simulator FMS: EK2-0905A (www.twf-sz.com) with
FMS Alpha 8.5.
Hopefully, I now can use my Falcon 40 Transmitter. The weight, size and
feel is different between the two transmitters.
Lamar
"Texman" <texman@[EMAIL PROTECTED]
> wrote in message
news:MlMkj.18799$%h3.18510@[EMAIL PROTECTED]
jim1977 a écrit :
: > Hi All,
: > Could someone please HELP me with the setup of my RD600 S****t
: > Transmitter to function correctly with FMS.? I have tried running
: > through the calibration settings, But i still cant get all functions
to
: > work correctly to get me up of the ground in any sort of stable
manner.?
: > my throttle doesnt seem to be setting right even after following the
: > calibration steps.? I would realy appreciate it if someone could tell
me
: > EXACTLY how to set this up.... What should i set the transmitter to.?
: > What settings should the switches be at before calibration.? I have
: > searched through the forum for anything on this isue and found some
: > info, but I would realy appreciate if someone with experience could
: > guide me through the setup so i can start practicing :)
: >
: > Thanks for any help offered guys..!! :)
: >
: >
: OK Jim,
: I'm using Alpha 8.5 Version but previous ones worked just the same.
: 1_ Have your Tx ready, connected and "on".
: 2_ Select from the top line menu "controls", then "analog controls"
: 3_ From next screen, select PCI interface
: 4_ From next screen, select COMx (usually COM1) and baud (usual 19200)
: 5_ Validate and go to mapping/calibrate
: 6_ On this screen, you select the ch# to funtion, note that you have a
: selection for airplanes and helis (move the sticks to find wich chan)
: select reverse and exponential(recommended) as needed.
: 7_ Now go to "calibrate" and move both sticks in circles to establish
: your sticks amplitudes (trims centered). After that, press "next" and
: set the center positions. Now press "finish", then "validate" and you
: will return to the first screen, press "validate" and you are done.
:
: Don't forget that the throttle/pitch stick is normally centered to
: enable inverted flying. You will get used to that very fast.
:
: Good luck and if anything is not clear, repost for clarifications.
: Texman
|
