by "Jim" <jim@[EMAIL PROTECTED]
>
Jul 4, 2008 at 09:28 PM
I bought the fan unit with motor with the airplane so couldn't tell you.
Another guy I met out in Phoenix used a HET (?) fan and motor I think it
was. Sorry I'm not much help.
"William R. Mattil" <wrmattil@[EMAIL PROTECTED]
> wrote in message
news:nmhbk.13005$xZ.8535@[EMAIL PROTECTED]
> Jim wrote:
>> You need a 70mm fan unit. A 3800-4500KV inrunner brushless motor that
>> will fit in the fan unit. You will need at least a 60A ESC and you will
>> need to run it on 4S-6S Lipos to get the speed you need. Be sure the
>> motor and ESC can handle the voltage!
>>
>> The instructions are atrocious. This airplane is a B-I-T-C-H to
>> build...trying to get the servo leads, power leads, etc. from the back
to
>> the front of the fuselage.
>>
>> I have built one but have yet to fly it.
>>
>>
>
>
> Jim,
>
>
> What motor and Batt's did you end up using ?
>
>
> Regards
>
> Bill
