Thank you Len.
Can not find any power supply. Do you know what voltage ac/dc? is
required. All I see is a possible edge connector position with about
6 contacts on it and no indication what it needs where.
Do you happen to know how it decides to reverse the current to the
drivewheel? Is it just time based or does it sense the resistance
when the car reaches the station?
Thanks again
On Jun 26, 8:53=A0pm, "Len" <lwnie...@[EMAIL PROTECTED]
> wrote:
> "RetroMIDI" <murray....@[EMAIL PROTECTED]
> wrote in message
>
>
news:3225e748-ed51-46c4-885a-4b53fcbefa2f@[EMAIL PROTECTED]
> : I am hoping that someone can give me advice about getting this
> : working.
> : The set is in good working order: motor, cables, pulleys all fine
> ...
> : BUT
> : control unit has been in mud ... possibly damaged ... not sure ...
> : DESPERATELY NEED tech spec for control unit ... I know where cable
> to
> : motor leaves the board.
> : But I DO NOT KNOW where the DC power enters the board or what the
> two
> : pots adjust.
> :
> : If someone is willing I am happy to scan or photograph the board so
> : you can look at it.
> :
> : Thank you
>
> One pot adjusts speed, the other is delay at station. There should be
> a jack for the power supply plug.
>
> Len
|
