"Ron Anderson" <ron@[EMAIL PROTECTED]
> wrote in message
news:aq1Rj.6874$GO4.3895@[EMAIL PROTECTED]
>
>
> "SteveB" <toquerville,utah@[EMAIL PROTECTED]
> wrote in message
> news:pgsce5-7n.ln1@[EMAIL PROTECTED]
>> Got a couple of particular questions for you if you do have one, or are
>> familiar with them. I'm getting mine running but having a couple of
>> simple
>> (hope so) glitches so far.
>>
>> Steve
>>
>>
> I may be able to help. What is your problems?
>
> --
> Ron Anderson A1 Sewing Machine
> 18 Dingman Rd Sand Lake, NY 12153
> http://www.a1sewingmachine.com
Downloaded the manual. Theaded machine as indicated. Found out how to
adjust stitch per inch. Found out that I was adjusting the wrong thumbnut
to adjust the thread tension so that the thread is not in a straight line
on
the bottom of the fabric. Haven't had time to try that yet.
My main problem is when getting ready to sew. I hand roll the wheel to
get
the needle to go down and pick up the bobbin thread. Then pull the two
ends
up through the holes. It seems most every time I sew, I get a tangle on
the
under side of the fabric where the bobbin thread tangles for some reason.
Should the top thread come out of the needle left to right, and the bobbin
thread come up through the hole, then the fabric go in between the two?
Sometimes it reaches the length of the top thread, then starts pulling
back
on the fabric.
I haven't had the time to mess with it today and try adjusting the correct
thread tensioning nut, but think that a lot of the problem of the thread
on
the underside being straight will be solved by that.
My main concern is the birdsnest at the start, or when the starting thread
gets to its end and pulls back on the fabric.
I'm sure that this is probably a simple matter, but it has me stupified
right now.
Thanks.
Steve
|
