On Fri, 02 May 2008 20:46:22 -0700, in rec.crafts.jewelry
yo****designs@[EMAIL PROTECTED]
>>I had Raytech CMF600 system,then recently machine is broken.
>>Anyway,I need replacement,If its same model It cost me about $1000.
>>one grade small (CMF400 system)is$480.or (CMF410---$579.)
>>
>>I do not need to finish so many pieces at one time.Also I can not
>>afford this money right now.
>>Then I found super mini magnetic polisher($169) in rio grande catalog
>>and remember some say this one was made in korea.
>>
>>So I 'd like to hear any opinion on this mini machine, also on Raytech
>>CMF400.
>>Thanks in advance and always appreciated this news group.
>>
>>Yo****.
I don't know where the super mini is made, but Raytech is a decent
brand/company
to deal with.
I've seen the super mini at shows. You should keep in mind that it's
REALLY
quite small. The container is about the size of a coffee cup. You can
tumble
perhaps two or three modest sized rings at a time, no more, and not much
of
anything larger than a ring.
But why not just get the larger machine you already have, repaired? Even
if
it's a whole new motor (the most expensive part), it can't be all that
much more
than the super mini, and might be less, and then you'd have your full
sized
machine back running again.
Peter
|
