That does seem strange but the CM11a is a pretty limited device and I
haven't used one in years so I don't remember how it worked when I had
one.
David White wrote:
> As always, thanks for the response, Bruce. That was a good guess. But
> alas, both the house code on the Tools menu and the Monitored Housed
> Code on the Config menu are both set to the same code as are the
> devices that are going on/off. I can see the activity when I turn the
> device on/off from inside Active Home or from a mini controller. So
> it seems odd that I do not see them when the CM11A generates them
> when running a macro.
>
> BruceR wrote:
>> Make sure that in the configuration menu you are monitoring the
>> correct housecode.
>>
>> David White wrote:
>>> Still somewhat of a newbie... I am using ActiveHome 1.42 with my
>>> CM11A. My computer is connected to the CM11A and the communications
>>> routines are running. But I when a macro I have downloaded into the
>>> CM11A goes off, I do not see anything in the communications log. I
>>> do, however, see the results of the macro being run. Is this
>>> expected behavior? Thanks.
|
